Water Heaters Only, Inc Phoenix completed a water heater repair for a 6 year old 40 gallon hot water heater that was not producing any hot water.
Upon arrival our technician diagnosed unit to have a failed pilot assembly, as the pilot would not hold a flame and the unit was unable to heat the water. He was able to open up the burner chamber, removed the failed pilot assembly, install the new pilot assembly, ensure the burner chamber was clear of any debris and looked in good working condition.
Our technician then resealed the burner chamber and light the pilot light. Once the pilot light was on, he set the temperature and watched to see the burner turn on. After the water heater has been heating up for a bit, he turned the temperature down to the lowest setting, the burner turned off as it should have, he then set the temperature at the recommended 120F degrees.
The home owner checked the hot water in the house and they had nice hot flowing water again.
The repair happened on N 54th Ave, Phoenix, AZ 85043 and only cost $350!